RFC-93 Pentek Comparable Tier1 Replacement Water Filter

SKU
TIER1-RFC-93
Price $17.99
Availability: In stock
Fits most 10 x 2 1/2 inch filter housings
  • Meets NSF Standard 42 for material structural integrity
  • Filter lasts approximately 6 months, depending on water quality and use
  • Radial flow acts like a turbine, ensuring carbon fines disappear
  • Fits most standard 10 x 2.5 inch housings
See more product details
The Tier1 RFC-93 filter cartridge is a great option for your point-of-entry system. It's standard 10 x 2.5 inch size fits in most 10 inch housings and other high flow rate applications. The RFC-93 filters down to 25 nominal microns in size, which will help eliminate Chlorine taste and odor. The filter's design incorporates a polyethylene shell and a polypropylene core, as well as radial flow that reduces the amount of carbon fines getting into your water. Most GAC filters have issues with carbon fines, the Tier1 RFC-93 eliminates those.

Experience the Tier1 Difference

Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:

  • Guaranteed Fit
  • Guaranteed Quality
  • Guaranteed Price
Package Qty 1
Used In Brands Pentek
Manufacturer's Id TIER1-RFC-93
UPC 641945742404
Advertised Size (in) 10 x 2-1/2
Media Radial Flow Granular Activated Carbon
Primary Filter Media Granular Activated Carbon
Filter Life (gallons) 5,000
Filter Life (liters) 18,927
Filter Life (months) 6 months
Micron Rating (Nominal) 25
Operating Temperature (°F) 40 - 125
Flow Rate (gpm) 1
Warranty Guarantee Unconditional Guarantee for Life of the Product
Primary Filter Media Granular Activated Carbon

The TIER1-RFC-93 is comparable with the following part numbers

PENTEK-RFC-93

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions