PD-10-30 Pentek Comparable Tier1 Replacement Sediment Water Filter

SKU
TIER1-P10-30
Price $13.99
Availability: In stock
Made to fit housings sized 30 x 2.5 inches
  • Filters contaminants down to 10 microns for 6 months
  • Has a higher dirt holding capacity to string wound filters
  • Great for commercial applications
  • Polypropylene media Impedes bacteria growth
See more product details
The PD-10-30 Pentek Comparable Tier1 Spun Wound Polypropylene Filter. This 30 x 2.5 inch spun wound polypropylene filter inhibits bacterial growth and serves as a layer of defense for your plumbing and health from potential water contaminant hazards. This filter ensures you are reducing water contaminants such as dirt, sediment, and silt. Spun wound filters have a higher dirt holding capacity than string wound filters which means you will get the most bang from your buck for the 6 months this filter is rated for. After this point you could otherwise experience lower flow rates as an indicator that the filter is heavily bogged down with contaminants. When replacing the filter it is recommended to replace your O-ring as well to help prevent leaking and keep your system functioning at its highest capacity. Let Tier1 be your water experts and protect every drop.

Experience the Tier1 Difference

Tier1 manufactures high-quality filtration and household products. We take creating and maintaining a healthy home seriously. Products must undergo rigorous testing and meet demanding quality expectations in order to earn the Tier1 badge. Every purchase is backed by the Tier1® Guarantee:

  • Guaranteed Fit
  • Guaranteed Quality
  • Guaranteed Price
Package Qty 1
Used In Brands Hydronix, Pentek, Tier1
Manufacturer's Id SDC-25-3010
UPC 799932614750
Advertised Size (in) 30 x 2-1/2
Actual Size (in) 30 inches (length) x 2 1/2 inches (outside diameter)
Actual Size (cm) 76.2 x 6.35
Media Spun Wound Polypropylene
Primary Filter Media Polypropylene
Filter Life (months) 6 months
Micron Rating (Nominal) 10
Operating Pressure (psi) 0 - 50
Maximum Operating Pressure (psi) 46.4
Operating Temperature (°F) 40 - 125
Operating Temperature (°C) 4.4 - 51.7
Flow Rate (gpm) 15
Color White
Warranty Guarantee Unconditional Product Guarantee for Life of the Product
Primary Filter Media Polypropylene

Contaminants

Reduces the following contaminants:

  • Dirt
  • Sand
  • Sediment
  • Silt

Instructions

  1. Turn off water supply. Press red pressure-relief button (if present)
  2. Unscrew housing. Remove large o-ring, wipe clean and set aside
  3. Discard used filter cartridge
  4. Wash housing with dish soap and warm water using a nonabrasive sponge or cloth. Rinse thoroughly
  5. Fill 1/3 with water. Add about 1 tablespoon of bleach and scrub to disinfect. Rinse thoroughly
  6. Lubricate o-ring with clean silicone grease. Change o-ring if any damage cuts or degradation are present. Insert o-ring in groove
  7. NOTE: This step is important to ensure a proper housing seal. Make certain the o-ring is seated level in the groove
  8. Insert new filter cartridge
  9. Screw housing onto the cap and hand-tighten. Do not over tighten. Make sure cap standpipe slips into cartridge
  10. Turn on water supply. Press pressure-relief button (if present). Check for leaks before leaving installation

Reset Instructions